Forums
AUG ELITE Gaming Community :: Forums :: AUG_Elite Community :: General Chat
 
<< Previous thread | Next thread >>
Controlling hardware of RPI3 with C/C++
Moderators: IKAIKA Dv8, VisionKill, Stack, EZPoacher, Phoenix Goddess, Nuke, Blues, asustek, Krash, Muarader
Author Post
Ryan Caleb
Wed Oct 11 2017, 11:13AM
Registered Member #1940
Joined: Thu Aug 31 2017, 09:58AM
Posts: 108
Thanked 0 times in 0 posts
Hii...


Recently, I've been getting into using C and C++, and was wondering if I could use them for, say, controlling the processor speed on the fly. Is this supported? If not, are there any other aspects of the hardware of the RPI that I can control or configure/tinker with using C/C++?

Thanks!

I didn't find the right solution from the Internet.

References:-https://www.raspberrypi.org/forums/viewtopic.php?f=63&t=195097&sid=b6bd59bef5ca11dceb734672c9dbf2c8

Demonstration Videos
Back to top
 

Jump:     Back to top

Syndicate this thread: rss 0.92 Syndicate this thread: rss 2.0 Syndicate this thread: RDF
Powered by e107 Forum System

This site is not responsible for any comments made by individuals. This is just a place where people can say what they want so you are looking at your own risk. This site is also uses a website system which is released under the terms of the GNU GPL License.


Anti-Spam Bots!



To view mobile Click Here
Anti Spam
Render time: 0.1194 sec, 0.0221 of that for queries.